Sntp; Alarm Settings - NetComm V210P User Manual

SNTP Settings
Simple Network Time Protocol (SNTP) can be used to sync the time on the NetComm ATA. If SNTP is enabled, your ATA clock is
synchronized with an Internet time server once a day. However, if you don't have a continuous Internet connection through a cable modem
or DSL modem, the automatic synchronization might not always occur.
Options
Primary Server
Secondary Server
Time Zone
Sync
If time synchronization fails, it might be for one of the following reasons:
• You are not connected to the Internet. Establish an Internet connection before you attempt to synchronize your clock.
• Your personal or network firewall prevents clock synchronization. Most corporate and organizational firewalls will block time
synchronization
• The time shown on your ATA is too different from the current time on the Internet time server. Internet time servers might not
synchronize your clock if your ATA's time is off by more than 15 hours.

Alarm Settings

Provide the alarm function. The alarm will sound when it reached the Alarm Time that you configured.
Options
Alarm
Alarm Time
Current time
Example 1: Alarm: ON, Alarm Time: 8:1(hh:mm)
The alarm will sound when it reached the current time 08:01.
VoIP Adapter User Guide
42
Description
Enter the primary NTP server name or IP address.
Enter the secondary NTP server name or IP address. The secondary server will be used if the
primary server becomes unreachable.
Enter the offset from GMT for your time zone.
Reports the synchronized time.
Description
Default is OFF (Disable). When it was ON (Enable), It will enable the Alarm function.
Default is 0:0 (hh:mm). Set the Alarm Time. (24 hours format, hh:mm)
The current time of the NetComm ATA.
YMLV21042 YMLV21042 V21042
www.netcomm.com.au