What To Do If - Electrolux EKD60950 User Manual

22 electrolux

WHAT TO DO IF...

Problem
The appliance does not operate The fuse in the fuse box is re-
The appliance does not operate You touched 2 or more sensor
The appliance does not operate There is water or fat stains on
The appliance does not operate The appliance is not switched on Switch on the appliance.
The appliance does not operate The clock is not set
The appliance does not operate The automatic cut-out is switch-
The oven does not heat up
The oven lamp does not operate The oven lamp is defective
The display shows F2
The display shows an error
code that is not in this list
Steam and condensation settle
on the food and in the oven cav-
ity
The residual heat indicators
does not come on
Heat setting alternates
comes on
comes on
comes on
Possible cause
leased
fields at the same time
the control panel
ed on
The necessary settings are not
set
• The door is not closed cor-
rectly
• The door lock is defect
There is an electronic fault
You left the dish in the oven for
too long
The cooking zone is not hot be-
cause it operated only for a
short time
The Power management is ac-
tive
The automatic switch-off oper-
ates
Overheating protection for the
cooking zone operates
No cookware on the cooking
zone
Remedy
• Control the fuse. If the fuse is
released more than one time,
refer to a qualified electrician.
• Check that the power plug is
properly inserted
• Check that any earth fault
switch is turned on
Only touch one sensor field.
Clean the control panel.
Set the clock.
Refer to "Automatic cut-out".
Control the settings.
Replace the oven lamp.
• Close the door correctly.
• Switch off the appliance with
the house fuse or the safety
switch in the fuse box and
switch it on again.
• If the display shows F2
again, refer to the Customer
Care Department.
• Switch off the appliance with
the house fuse or the safety
switch in the fuse box and
switch it on again.
• If the display shows the error
code again, refer to the Cus-
tomer Care Department.
Do not leave the dishes in the
oven for longer than 15-20 mi-
nutes after the cooking process
ends.
If the cooking zone must be
hot, speak to the After Sales
Service.
See the section Power manage-
ment.
Stop the appliance and start it
again.
Switch off the cooking zone.
Switch on the cooking zone
again.
Put cookware on the cooking
zone.