Electrolux EKD60950 User Manual page 24

24 electrolux
850 to 920 mm. The distance between
the holes is between 7 mm and 14 mm.
5. Lift the appliance up and connect to the
mains.
Important! Use small feet on the bottom of
appliance to set same level of cooker top
surface with other surfaces.
Important! Always adjust the appliance
horizontally before first use.
Horizontal adjustment
Important! When you instal the appliance
set the appliance top surface horizontally.
Use a screwdriver to adjust the wheels. You
can adjust the cooker wheels and feet by
15 mm.
• Appliance left the factory fully packaged.
If it is delivered without packaging and
damage has occurred, the manufacturer
cannot accept responsibility. Contact
your supplier for advice.
• Do not move the appliance by hand after
removed the packaging. Do not use a
sack barrow or any other aid to lift the ap-
pliance. It can cause a damage.
• To move the appliance, open the oven
door and lift the appliance by holding in-
side the top of the component.
• You can fit your freestanding appliance
with cabinets on one or both sides and in
the corner.
• Protect sidewalls above the hob level by
heat resistant noncombustible material
and provide minimum 40 mm distance
from the sidewalls to the hob side.
• Provide minimum 2 mm air gap at either
side of the appliance to enable moving it
into position.
• Surfaces above the hob (also cooker
hoods) must be a minimum of 685 mm
above the hob.
The anti-tilt protection
Caution! You must install the anti-tilt
protection (A+B). If you do not install it
the appliance can tilt.
Before you install anti-tilt protection, ad-
just the appliance to the correct height.
The anti-tilt protection has two parts (A+B).
You can find the anti-tilt protection (B) on
right or left side of the rear wall of the appli-
ance (See fig. 1). You must install the anti-
tilt protection (A) on the wall. The distance
of the hole of the anti-tilt protection (A) from
the floor is about 816 mm. Make sure you
install the anti-tilt protection (A) at the cor-
rect height. Screw it into the solid material
or use applicable reinforcement.
Check that the anti-tilt protection projects
minimum 20 mm into the hole in the back
of the appliance (B) when you push the ap-
pliance (See fig. 2). If the space between
the bench cupboards is greater than the
width of the appliance, you must adjust the
side measurement to centre the appliance.
Make sure that the surface behind the appli-
ance is smooth.
50 mm
60 mm
A
1
2
Electrical installation
Warning! Only a qualified and
competent person must do the
electrical installation.
60 mm
50 mm
A
B