Engine Oil And Oil Filter Element - Yamaha XVS1100 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
a. Spark plug gap
To install a spark plug
1. Measure the spark plug gap with a
wire thickness gauge and, if nec-
essary, adjust the gap to specifica-
6
tion.
Spark plug gap:
0.7–0.8 mm
2. Clean the surface of the spark
plug gasket and its mating sur-
face, and then wipe off any grime
from the spark plug threads.
3. Install the spark plug with the
spark plug wrench, and then tight-
en it to the specified torque.
Tightening torque:
Spark plug:
20 Nm (2.0 m·kg)
NOTE:
@
If a torque wrench is not available when
installing a spark plug, a good estimate
of the correct torque is 1/4–1/2 turn
past finger tight. However, the spark
plug should be tightened to the speci-
fied torque as soon as possible.
@
4. Install the spark plug cap.
5. Place the spark plug cover in the
original position.
6-7
1. Oil level check window
2. Maximum level mark
3. Minimum level mark
Engine oil and oil filter
element
The engine oil level should be checked
before each ride. In addition, the oil
must be changed and the oil filter ele-
ment replaced at the intervals specified
in the periodic maintenance and lubri-
cation chart.
To check the engine oil level
1. Place the motorcycle on a level
surface and hold it in an upright
position.
EAU01712