Rear Wheel Installation - Yamaha Drag Star XVS650 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
1. Bolt ( 4)
4 2. Final gear case
3. Axle nut
6. Remove the bolts that secure the
5
final gear case to the swingarm.
7. Elevate the rear wheel off of the
6
ground.
8. Pull the wheel backward while
7
supporting the drive shaft to re-
move the wheel, axle, final gear
8
case and drive shaft as an assem-
bly.
9
1. Middle drive shaft joint
2. Drive shaft

Rear wheel installation

1. Install the rear wheel, axle, final
gear case and drive shaft as an
assembly by pushing the wheel
forward and guiding the drive
shaft into the middle drive shaft U-
joint.
2. Install the bolts that secure the fi-
nal gear case to the swingarm
and tighten to the specified tight-
ening torque.
Specified torque:
Final gear case bolts:
90 Nm (9.0 m·kg)
6-33
3. Insert the brake rod into the brake
cam lever and install the brake
pedal free play adjusting nut.
4. Install the brake torque rod bolt
and tighten both bolts to the spec-
ified tightening torque.
Specified torque:
Brake torque rod bolts:
20 Nm (2.0 m·kg)
EAU01563
5. Install panel A.
6. Let the motorcycle down.
7. Tighten the axle nut to the speci-
fied tightening torque.
Specified torque:
Axle nut:
92 Nm (9.2 m·kg)
8. Adjust the rear brake pedal free
play. (See page 6-20.)