Replacing The License Plate Light Bulb; Replacing An Auxiliary Light Bulb - Yamaha YZF-R1S Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
Replacing the license plate
light bulb
1. Remove the license plate light unit
by removing the screws.
1. Screw
6
2. License plate light unit
2. Remove the socket (together with
the bulb) by pulling it out.
1. License plate light bulb
EAU24310 3. Remove the defective bulb by pull-
ing it out.
4. Insert a new bulb into the socket.
5. Install the socket (together with the
bulb) by pushing it in.
6. Install the license plate light unit by
installing the screws.
6-36
Replacing an auxiliary light
bulb
This model is equipped with two auxil-
iary lights. If an auxiliary light bulb burns
out, replace it as follows.
1. Remove panel A (if replacing the
left auxiliary light bulb) or panel C
(if replacing the right auxiliary light
bulb). (See page 6-6.)
2. Remove the auxiliary light bulb
cover by removing the quick fas-
tener.
NOTE:
Remove the quick fastener by pushing
the center pin in with a screwdriver,
then pulling the fastener out.
1. Quick fastener
2. Auxiliary light bulb cover
EAU33910