Adjusting The Seat Height - Yamaha YZF-R1S Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS

Adjusting the seat height

This model is equipped with a seat
height adjusting bolt. Adjust the seat
height as follows.
1. Remove the bolt, loosen and re-
move the quick fastener screw,
and then pull the cowling away
3 from the motorcycle.
1. Quick fastener screw
2. Bolt
3. Cowling
2. Loosen the relay arm connecting
rod bolts.
EAU39261
1. Relay arm connecting rod
2. Relay arm connecting rod bolt
3. Seat height adjusting bolt
4. Distance A
3. To increase the seat height, turn
the adjusting bolt in direction (a).
To decrease the seat height, turn
the adjusting bolt in direction (b).
NOTE:
G
The longer distance A is, the lower
the seat height. The shorter dis-
tance A is, the higher the seat
height.
G
The minimum seat height is the
standard setting [adjusting bolt ful-
ly turned in direction (b)].
4. Tighten the relay arm connecting
rod bolts to their specified torque.
3-26
Tightening torque:
Relay arm connecting rod bolt:
8.0 Nm (0.8 m·kgf, 5.8 ft·lbf)
5. Place the cowling in its original po-
sition, install and tighten the quick
fastener screw, and then install the
bolt.
6. Adjust the drive chain slack. (See
page 6-23.)