What To Do If - AEG BE5013001 User Manual

30

What to do if...

2. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
3. Pull the door trim to the front to re-
move it.
4. Hold the door glass panels on their top
edge one by one and pull them up out
of the guide
5. Clean the door glass panels.
To install panels follow the procedure in re-
verse. Install the smaller panel first, then the
larger.
WHAT TO DO IF...
WARNING!
Refer to "Safety information" chapter.
Problem
The oven does not heat up
The oven does not heat up
The oven does not heat up
The oven does not heat up
The oven does not heat up
The oven lamp does not oper-
ate
Possible cause
The appliance is switched off
The clock is not set
The necessary settings are not
set
The automatic cut-out is
switched on
The fuse is released
The oven lamp is defective
B
Solution
Switch on the appliance
Set the clock. Refer to "Setting
the clock"
Make sure, the settings are cor-
rect
Refer to „Automatic cut-out"
Make sure, if the fuse is the
cause for the malfunction. If
the fuse releases again and
again, refer to an authorized
electrician
Replace the oven lamp.