Installation - AEG B9872-5 User Manual

26

Installation

Problem
The oven lamp does not oper-
ate.
The display shows C1.
The display shows F11.
The display shows F2.
The display shows an error
code that is not in this list.
The turn spit does not rotate.
The turn spit does not rotate.
If you cannot find a solution to the problem yourself, contact your dealer or the service
centre.
The necessary data for the service centre is on the rating plate. The rating plate is on the
front frame of the oven cavity.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
INSTALLATION
WARNING!
Refer to "Safety information" chapter.
Possible cause
The oven lamp is defective.
You want to start the pyrolytic
cleaning but you did not re-
move the shelf rails (or tele-
scopic shelf rails).
• There is a short circuit of
the meat probe.
• The meat probe plug is not
correctly installed into the
meat probe socket.
• The door is not closed cor-
rectly.
• The door lock is defect.
There is an electronic fault.
The necessary oven function is
not set.
The turn spit is not correctly in-
stalled into the turnspit hole.
Solution
Replace the oven lamp.
Remove the shelf rails (or tele-
scopic shelf rails) from the
oven.
Install the meat probe plug as
far as possible.
• Close the door correctly.
• Switch off the appliance
with the house fuse or the
safety switch in the fuse
box and switch it on again.
• If the display shows F2
again, refer to the Custom-
er Care Department.
• Switch off the appliance
with the house fuse or the
safety switch in the fuse
box and switch it on again.
• If the display shows the er-
ror code again, refer to the
Customer Care Department.
Refer to "Oven functions".
Refer to "Turn spit".
.........................................
.........................................
.........................................