Safety Harness; Parking Brake; Adjusting The Brake - Baby Jogger PERFORMANCE SINGLE Assembly Instructions Manual

Safety Harness

1 2
Unclip top of shoulder strap To adjust the strap length: Remove the shoulder pads and move
from the seat and re-clip on the plastic guide up or down to lengthen or shorten.
the pair of seat loops closest
to child's shoulder height.
3
To unbuckle the harness:
Press one side of the
center button and pull
corresponding side
buckle sway from the
center buckle. Repeat to
unbuckle other side.
To buckle: Simply push
side buckle into center
buckle until it locks
in place.
Warning: always use the crotch strap in combination with the waist belt.
aVOiD SEriOUS inJUrY FrOM FaLLing Or SLiDing OUT.
aLWaYS USE THE SaFETY HarnESS.
6

Parking Brake

Hand Brake
Hand Brake
4
• To use the hand button feature, simply squeeze the brake handle.
To adjust side
straps: Press side
buckle latch and
slide strap to
lengthen or shorten.
5
To adjust the center
strap: Move its plastic
Cylinder
guide up or down.
Ring
• Simply push brake pedal down
to engage rear parking brakes
and lift up to release.

Adjusting the Brake

• If you do not have good braking action, simply squeeze
the brake lever five or six times. If the problem persists,
turn the cylinder ring clockwise and then turn the small
Small
ring counter clockwise to tighten the cable. To lock ring,
Ring
hold the cylinder ring while turning the small ring
counter clockwise.
NoTe: Engage parking device during the
loading and unloading of passengers.
Warning: Engage
parking device before
loading and unloading
passenger.
7