Table of Contents
Advertisement
Before using your dishwasher for the first time
1. Ensure that the electrical and water connections comply with the installation
instructions.
2. Remove all packaging from inside the appliance.
3. Set the water softener.
4. Pour 1 litre of water inside the salt container and then fill with salt.
5. Fill the rinse-aid dispenser.
Setting the water hardness range
The dishwasher is equipped with a water softener designed to remove minerals and
salts from the water supply, which would have a detrimental or adverse effect on the
operation of the appliance.
The higher the content of these salts, the harder your water is.
Water hardness is measured in equivalent scales, German, French degrees and PPM
(parts per Million).
The softener should be adjusted according to the hardness of the water in your area.
Your local Water Authority can advise you on the hardness of the water in your area.
The dishwasher is factory set at level 3.
If this level is not suitable for your area the softener should be adjusted.
You may change the factory level setting by means of the wash programme selector
push buttons. each push button corresponds to a different level.
If your water hardness is level 1 it is already soft and therefore there
is no need to use salt. With the setting of the water softener at level
1 the salt indicator light on the control panel will always remain off.
46
L
evel 1 = "Rinse and Hold" push button
Level 2 = "Intensive 70°"
Level 3 = "Normal 65°"
Level 4 = "Bio 50°"
Level 5 = "Breve 50°"
push button
push button
push button
push button
BIO
Advertisement
Table of Contents
