Table of Contents
Advertisement
What to do, when...
Try to rectify minor faults on the dishwasher with the aid of the instructions given
here.
...a flashing fault code appears
If on the control panel one o more programme indicator lights are flashing, they are
indicative of a fault in the dishwasher that you can probably rectify yourself.
Open the door, press the On/Off push button to switch the dishwasher off and with
the aid of the malfunctions listed below try to rectify the fault condition.
Fault code
"Rinse and hold" and
"Normal 65°" indicator
lights are flashing
"Intensive 70°" e "Normal
65°" indicator lights are
flashing
"Normal 65°" indicator
light is flashing
Other indicator lights or
combinations of indicator
lights are flashing
Once checked the possible causes listed above, switch on the dishwasher and start a
wash programme, if the fault code reappears contact the service centre.
62
Possible cause
The water tap is closed.
The mains water supply has
been cut off.
The inlet hose may be
squashed or bent.
The inlet hose may be
blocked.
The drain hose may be
squashed or bent. The drain
hose extension is not
correct.
The sink may be blocked.
Protection against flooding
is active.
General
Remedy
Open the water tap.
Reposition correctly the
hose.
Switch off the water
supply and clean the filter.
Reposition correctly the
drain hose. Follow the
instructions for
connecting to the waste.
Clear any blockages.
Close the water tap and
contact the service centre.
Open the door, switch off
the dishwasher, switch
back on and start a wash
programme. If the fault
code reappears contact
the service centre.
Advertisement
Table of Contents
