Front Wheel - Yamaha MT-03 Owner's Manual

To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a mo-
torcycle stand is not available, by plac-
ing a jack either under each side of the
frame in front of the rear wheel or un-
der each side of the swingarm.
PERIODIC MAINTENANCE AND MINOR REPAIR

Front wheel

To remove the front wheel
WARNING
0
G
It is advisable to have a Yama-
ha dealer service the wheel.
G
Securely support the motorcy-
cle so that there is no danger of
it falling over.
1. Front wheel axle pinch bolt
2. Wheel axle bolt
3. Brake caliper bolts
4. Brake hose holder bolt
6-37
EAU24360 1. Lift the front wheel off the ground
according to the procedure on
EAU34390
page 6-36.
2. Loosen the front wheel axle pinch
EWA10820
bolt, then the wheel axle and the
brake caliper bolts.
3. Remove the brake hose holder on
each side by removing the bolts.
4. Remove the brake caliper on
each side by removing the bolts.
CAUTION:
Do not apply the brake after the
brake calipers have been removed,
otherwise the brake pads will be
forced shut.
5. Pull the wheel axle out, and then
remove the wheel.
To install the front wheel
1. Lift the wheel up between the fork
legs.
2. Insert the wheel axle.
3. Lower the front wheel so that it is
on the ground.
1
2
3
4
ECA11050
5
6
7
8
EAU24860
9
10