Table of Contents
Advertisement
Removable Frontline strip
The aluminium Frontline strip fastens on by means of magnets. It is
easy to remove by hand and can be cleaned with detergent. Please do
not use any scouring agents or sponges that scratch. Do not clean the
strip in the dishwasher.
What to do if ...
Problem
The cooking zones will not
switch on or are not func-
tioning
The residual heat indicator
is not displaying anything
The automatic warm-up
function is not switching
itself on
e and number are dis-
played
Possible cause
More than 10 seconds have
passed since the appliance
was switched on
The child safety device is
switched on l
Several sensor fields were
touched at the same time
The sensor fields are partly
covered by a damp cloth or
with liquid
Safety cut-out has been
triggered
STOP+GO is activated u
The cooking zone was only
on for a short time and is
therefore not hot
The highest heat setting is
Ç
set
Electronics fault
Remedy
Switch the appliance on
again.
Deactivate the child safety
device (See the section
"Child safety device")
Only touch one sensor field
Remove the cloth or the
liquid.
Switch the appliance on
again.
Switch the appliance on
again
Switching off STOP+GO
If the cooking zone is sup-
posed to be hot, call your
local Service Force Centre.
The highest heat setting
has the same power as the
automatic warm-up func-
tion
Disconnect the appliance
from the electrical supply
for a few minutes (Take the
fuse out of the house's wir-
ing system)
If after switching on again,
e is displayed again, call
the customer service de-
partment
21
Advertisement
Table of Contents
