Prior To Using For The First Time; Adjust The Water Softener - Electrolux ESI 662 User Instructions

Prior to using for the first time

Prior to using for the first time, remove all the clips
with which the dish racks are secured for transport.
Then perform the following steps:

1. Adjust the water softener

2. Filling with Special Salt for the Water Softener
3. Filling with Rinse Aid
Adjust the water softener
To avoid the scale deposits on the dishes and in the
dishwasher, the dishes must be washed with soft, i.e.
low lime content, water. The dishwasher therefore
has a built-in water softener, in which tap water from
a hardness of 4 °d (German degree) is softened with
the aid of special salt.
Water Hardness
1
in °d ) in mmol/l
41-50 7.3-9.0
35-40 6.3-7.2
31-34 5.5-6.2
27-30 4.8-5.4
23-26 4.1-4.7
19-22 3.3-4.0
15-18 2.6-3.2
11-14 1.9-2.5
4-10 0.7-1.8
under 4 under 0.7
1)(°d) German degree, measure of the hardness of water
2)(mmol/l) millimol per litre, international unit for the hardness of water
*factory setting
1. The dishwasher must be switched off.
2. Press the function and water softener buttons
simultaneously and keep them pressed
3. In addition press the ON/OFF switch
The LED indicators for the function and water sof-
tener buttons flash.
4. Press the softener button again.
The multi-display indicates the hardness setting.
5. Pressing the water softener button increases the
hardness setting by 1.
(Exception: hardness setting 0 follows hardness
setting 9).
6. When the hardness setting is correct, press the
M
ON/OFF switch .
The hardness setting is then saved.
2
) Range
IV
III
II
I/II
I
M
.
You water supplier will be able to inform you
3
on the hardness and hardness range of the
water in your area.
Adjust the water softener to the setting given
in the table that corresponds to the hardness
of the water in your area. The water softener
can be adjusted in 10 steps.
Adjust
to Hardness Setting
9
8
7
6
5
4
3*
2
1
0
no salt necessary
Indication on the
Multi-Display
H 9
H 8
H 7
H 6
H 5
H 4
H 3
H 2
H 1
H 0
9