Built-In Dishwasher; Free-Standing Appliances - Electrolux ESI 662 User Instructions

Built-In Dishwasher

(see enclosed installation instructions)

Free-Standing Appliances

can be set up as stand-alone without addi-
1
tional installation.
If the dishwasher is set up next to a cooker, a
heat-insulating, non-flammable plate must be
mounted between the dishwasher and the
cooker, flush to the top edge of the work sur-
face (depth 57.5 cm). The plate should have
aluminium foil on the side facing the cooker.
If the dishwasher is installed underneath a kitchen
work surface, the original work surface of the dish-
washer is to be removed as follows:
1. Unscrew the screws (1) from the elbows on the
back side.
2. Slide the work surface approx. 1 cm to the rear (2),
lift at the front (3) and remove.
3. Press the work surface retaining brackets at the
position (4) shown in the diagram and remove the
bracket at an angle to the rear (5).
If the dishwasher is later used as a free-
1
standing appliance, the original work surface
must be re-mounted.
The plinth on free-standing appliances is not
3
adjustable.
• Free-standing appliances can be fitted with a
décor panel to match the facings of other kitchen
equipment. The décor panels must be obtained
from the kitchen manufacturer. A décor frame is
necessary for installation, and can be obtained as
an accessory from the dealer if not included in the
scope of delivery.
• Decor panel dimensions:
– Height 597mm
– Width 587mm
– Clamp thickness: max. 4mm
• The corners of the décor panels must be cham-
fered at 5 mm x 45°.
• To ensure that thin decor panels do not flex or dis-
tort, attach them to the door of the appliance using
double sided adhesive tape.
28
4
5