Table of Contents
Advertisement
Indicator lights:
have the following meanings:
salt refilling indicator light, illuminates when the salt
has run out
rinse aid refilling indicator light, illuminates when
the rinse aid has run out
The salt and rinse aid indicator lights are never illuminated
while a washing programme is running even if filling with salt
and rinse aid is necessary.
Prior to using for the first time
Before using your dishwasher for the first time:
1. Ensure that the electrical and water connections comply
with the installation instructions
2. Remove all packaging from inside the appliance
3. Set the water softener
4. Pour 1 litre of water inside the salt container and then fill
with salt
5. Fill the rinse aid dispenser
Setting the water softener
The dishwasher is equipped with a water softener designed to
remove minerals and salts from the water supply, which would
have a detrimental or adverse effect on the operation of the
appliance.
The higher the content of these salts, the harder your water is.
Water hardness is measured in equivalent scales, German
degrees, French degrees and PPM (parts per Million).
Water hardness
°dH
°TH
(german degrees)
(french degrees)
91 - 125
51 - 70
43 - 50
76 - 90
37 - 42
65 - 75
51 - 64
29 - 36
23 - 28
40 - 50
19 - 22
33 - 39
26 - 32
15 - 18
11 - 14
19 - 25
4 - 10
7 - 18
< 7
< 4
All manuals and user guides at all-guides.com
Adjusting the water hardness
PPM
manually
(parts per million)
901 - 1250
2
751- 900
2
641 - 750
2
501 - 640
2
391 - 500
2
321 - 390
2
251 - 320
1
181 - 250
1
70 - 180
1
< 70
1
24
Phase indicator lights:
washing: illuminates when the washing phase is
running
drying: illuminates when the drying phase is
running
end of programme: illuminates when the washing
programme has ended
As soon as you select a washing programme, the phase
indicator lights for that programme will illuminate.
As the programme starts, the phase indicator lights turn off
except for the indicator light of the phase in progress.
The softener should be adjusted according to the hardness of
the water in your area. Your local Water Authority can advise
you on the hardness of the water in your area.
The water softener must be set in both ways: manually, using
the water hardness switch and electronically, using the function
push buttons on the control panel.
If your water is level 1 it is already soft and therefore there
is no need to use salt.
Setting manually
The dishwasher is factory set at position 2.
1. Open the dishwasher door.
2. Remove the lower basket from the dishwasher.
3. Turn the water hardness
switch to position 1 or 2
(see table).
4. Replace the lower basket.
Level indicated
setting
digital display
electronically
level 10
level 9
level 8
level 7
level 6
level 5
level 4
level 3
level 2
level 1
have the following meanings:
AA07
Use
in the
of salt
yes
yes
yes
yes
yes
yes
yes
yes
yes
no
Advertisement
Table of Contents
