Dishwashers That Can Be Integrated; Built-In Dishwasher; Free-Standing Appliances - Electrolux ESF 642 User Instructions

Table of Contents

Advertisement

Depending on type, the dishwasher is to be installed as follows:
Dishwashers That Can Be Inte-
grated
(see installation template supplied)
The door of the appliance can be fitted with a
3
wooden furniture door with the following
dimensions
Width:
Thickness:
Height:
(variable)
Weight:
If the facing panel is longer than 600 mm, the
1
door of the appliance cannot be opened
completely (the facing panel bumps against
the plinth).
If this is the case, the plinth must be cut out
(see installation template) or the brace
adapter for the extra long door BLT 60 must
be used. You can obtain this with the E No.
911 239 008.

Built-In Dishwasher

(see enclosed installation instructions)

Free-Standing Appliances

can be set up as stand-alone without addi-
1
tional installation.
If the dishwasher is set up next to a cooker, a
heat-insulating, non-flammable plate must be
mounted between the dishwasher and the
cooker, flush to the top edge of the work sur-
face (depth 57.5 cm). The plate should have
aluminium foil on the side facing the cooker.
If the dishwasher is installed underneath a kitchen
work surface, the original work surface of the dish-
washer is to be removed as follows:
1. Unscrew the screws (1) from the elbows on the
back side.
2. Slide the work surface approx. 1 cm to the rear (2),
lift at the front (3) and remove.
3. Press the work surface retaining brackets at the
position (4) shown in the diagram and remove the
bracket at an angle to the rear (5).
591 – 594 mm
16 – 24 mm
dependent on
max. 8 kg
- Recess height
- Plinth height
- The adjustment so that the unit matches the height
of the adjoining units
The exact height of the adjoining units must be
measured at the place of installation.
4
5
25

Advertisement

Table of Contents
loading

Table of Contents