Remote Handset - Audiolab 8000AP User Instructions

6: Remote Handset

1&
DISPLAY Q-SET MENU NIGHT
1^
MODE STEREO BAL MUTE
1%
1$
ENTER
BACK VOLUME
1#
DTV DVD CD
DAB MD DX1
1@
DX2 HDMI1 HDMI2
TV VCR SAT
AUX TAPE 5.1
1 MENU Enter/leave the on-screen setup menu
2 STANDBY Bring the unit in/out of Standby mode
3 NIGHT Toggle "Night" mode on/off
4 MUTE Mute/unmute the sound
b
5 BALANCE Adjust left/right balance of font speakers
c
d {
ENTER
e
6
{
ENTER
f
g
7 VOLUME Adjust the Volume level
8 Co-axial digital input selection
h
9 HDMI input selection
10 analogue input selection
i
11 5.1 5.1 analogue input key
12 Optical digital input selection
j
13 BACK Return to main menu options (in Setup mode)
1)
14 STEREO Down-mix a multi-channel signal to stereo
Cycle analogue and digital processing modes
15 MODE
1!
Toggle the display off/on
16 DISPLAY
Enter/leave the front panel setup menu
17 Q-SET
Page 8
Navigation buttons (in Setup menu)
Adjust Balance (During Play)
Confirm an action (in Setup menu)
Access setup options (During Play)
Fitting Batteries
Open the cover. Unwrap the supplied AAA batteries
and place them in the battery compartment with the
polarity as shown. Replace the cover.
Always use AAA batteries and always replace them in
sets. Never mix old and new batteries. Very weak
batteries can leak and damage the handset. Replace
them in good time!
Do NOT short circuit batteries or throw them into
water, the general rubbish or a fire. Dispose of used
batteries with regard to recycling regulations in your
area.
1: Open the battery
2:Insert 2AAA batteries
compartment cover
3: Replace the cover
Handset Operation
Point the handset at the 8000AP display window
and press the relevant key. The handset should be
within 15 metres of the 8000AP and there must be
a clear line of sight between the two units.