Remote Handset; Fitting Batteries; Handset Operation - Audiolab 8300A User Instructions

4: Remote Handset

NOTE : the handset buttons shown crossed out are for use with other 8300CD
Audiolab units and are not operational when used with the 8300A
1 STANDBY Press to bring the unit in/out of Standby
2 MENU Press to enter menu mode
3 Move to next menu page or setting
4 VOL– Press to decrease Volume
5 XLR Press to select XLR input
6 PHONO Press to select Phono input
7 VIDEO Press to select Video input
8 TUNER Press to select Tuner input
9 DISPLAY Press to toggle the display on/off
Press and hold to select display brightness levels
10 MM/MC Press to toggle Phono MM/MC mode
11 AUX2 Press to select Aux2 input
12 AUX1 Press to toggle different digital input
13 CD Press to select CD input
14 Press to select menu page or setting
15 Move to last menu page or setting
16 MUTE Press to mute and unmute the sound
Page 4

Fitting Batteries

Open the cover, unwrap the supplied AAA batteries and
place them in the battery compartment with the polarity as
shown, replace the cover.
Always use AAA batteries and always replace them in sets.
Never mix old and new batteries. Very weak batteries can
leak and damage the handset. Replace them in good time!
There is a risk of fire and burns if a battery is handled
improperly. Do not disassemble, crush, puncture, short
external contacts, or dispose of in fire or water.
Do not attempt to open or service a battery. Discard used
batteries in full accordance with recycling regulations in
force in your area.

Handset Operation

The handset operates several Audiolab components. The
handset buttons shown crossed out are for use with other
Audiolab units and are not operational when used with the
8300A.
Point the handset at the remote receiver and press the
relevant key. The handset should be within 15 meters of the
player and there must be a clear line of sight between the
two units.