Table of Contents
Advertisement
8c: Operation - 3
Volume Control
The
VOLUME
knob,
and the
VOL
keys on the handset
control the level of all connected loudspeakers. They do not
.
affect the TAPE or DIGITAL OUT sockets
Turn the
VOLUME
knob clockwise to increase the volume or
anticlockwise to decrease the volume in 1dB steps. When you
reach either end of the volume range, you will still be able to
rotate the knob but the volume will stop changing.
The volume is alterable from
-90dB
(very low) to
(
very
loud). The Volume level appears in the display. If you go
below -90dB the 8000AP will mute and the word MUTE will
appear in the display.
Note:
The 8000AP remembers the volume when put into
Standby and returns to this volume when next switched on. If
the last used volume is above -20dB, the 8000AP will power
on at a level of -20dB. This eliminates surprises caused by a
high previous volume setting.
Mute
To mute all speaker outputs press the
MUTE
button on the
front panel or the mute key on the remote control. To restore
the volume press MUTE again.
Note:
If you have turned the volume down manually below
the -90dB mark, the MUTE display will not turn on or off when
you press the
MUTE
key.
The 8000AP mutes momentarily whenever you change inputs
or undertake certain functions.
Altering the Front Speakers Balance
Press the BALANCE key on the front panel or the remote
control to enter Balance Mode
Alter the balance to the Right or Left by rotating the Volume
knob or the Left/Right
keys on the handset.
keys
held down will move the sound progressively
further left or right
.
Press the
BALANCE
key on the front panel or the remote
control to exit Balance Mode
If you do nothing, after a short period the 8000AP will
automatically exit Balance Mode.
–
VOLUME
+15dB
MUTE
DVD
VOL MUTE
3/3.1
ES Discrete
BAL
A
balance
B
–
Keeping the
ENTER
ENTER
Balance Control
L= 0.0dB
R= 0.0dB
Night Mode
This mode works with Dolby Digital or DTS Digital Surround
sources which include Night Mode control parameters. Night
Mode reduces the dynamic range for quieter listening, so that
you can comfortably hear quieter passages at lower volume
levels -low levels are boosted, high levels are cut.
+
Press
NIGHT MODE
on the handset to toggle Night Mode
On
or
Off
Night Mode will remain active until it is switched off.
Always switch this mode off after use.
Forced Stereo Operation
Pressing the
STEREO
key on the handset down-mixes a multi-
channel signal to a stereo (front left/right) signal only (the
stereo signal is created from all channels).
The subwoofer will appear in the Active Channels display if
the Front speakers have been set to Small or if the bass
management in the Setup menu has been set to L+R= to
mute
Sub.
Display On/Off
Pressing the
DISPLAY
key on the handset switches the display
off and on. When the 8000AP is operational and the display
is switched off only the Standby light remains on to show the
unit is active.
If you set the 8000AP to Standby when the display is switched
off, when you bring the unit out of Standby the display will
restore.
+
Page 15
Night Mode = On
Night Mode = Off
Stereo Mode
(Subwoofer Enabled)
Stereo Mode
(Subwoofer Disabled)
Hide quick links:
Advertisement
Table of Contents
