Remote Handset - Audiolab 6000A Play User Manual

5: Remote Handset

NOTE : the handset buttons shown crossed out are for use with other Audiolab units like
Audiolab 6000CDT and are not operational when used with the 6000A Play
1 STANDBY Press to bring the unit in/out of standby
2 VOL+ Increase volume
3 VOL- Decrease volume
4 DISPLAY Press to toggle the display on/off
5 A Press to select 6000A Play remote mode
6 CD Press to select 6000CDT remote mode
7 SOURCE Press to cycle source inputs
8 MODE Press to select 6000A Play operating mode
9 MUTE Press to mute and unmute the sound
10 MENU Press to enter menu
11
Move to the previous track
Move to the previous page or setting in menu
12 Press to start / pause
Press to confirm page or setting selected in menu
Press and hold to disconnect the Bluetooth
13 Move to the next track
Move to the next page or setting in menu
Fitting Batteries
The remote control requires 2 x AAA type batteries.
Due to international shipping and courier regulations
with Lithium Ion batteries, the remote controller
batteries are not included in this package.
Always use AAA batteries and replace them in sets
-never mix old and new batteries.
Handset Operation
The handset operates several Audiolab components.
The handset buttons shown crossed out are for use
with other Audiolab units and are not operational
when used with the 6000A Play.
Point the handset at the remote receiver and press
the relevant key. The handset should be within 15
meters of the player and there must be a clear line of
sight between the two units.
Page 6