Windows New Hardware Found - ATI Technologies ALL-IN-WONDER 9200 Installation And Setup User's Manual

12 Installing the Hardware and Software
4
5
6
7

Windows New Hardware Found

Windows may start the Add New Hardware Wizard to install
the Standard VGA Driver. To correctly install your new
hardware:
If you are using Windows 2000 or Windows XP, Cancel the
Wizard and proceed to
Suite
• If the Add New Hardware Wizard does not appear, proceed
to
• If the Add New Hardware Wizard does appear:
1
2
3
Remove any existing graphics card from your computer.
If your computer has an on-board graphics capability, you
may need to disable it on the motherboard. For more
information, see your computer documentation or contact
the manufacturer.
After locating the AGP slot, and if necessary, removing the
metal cover, align your ALL-IN-WONDER card with the
AGP slot, and press it in firmly until the card is fully
seated.
Replace the screw to fasten the card in place, and replace
the computer cover.
Plug the ATI Output Adapter into your card (see
and then attach the monitor cable.
on page 13.
Installing the CATALYST™ Software Suite
Click Next to allow Windows to search for the Standard
VGA or Standard PCI Graphics Adapter.
If prompted for the Windows CD-ROM, insert it into your
CD-ROM drive.
Type the following: D:\operating system name (for
example, D:\WinME).
If D is not your CD-ROM drive, substitute the correct drive
letter.
Click OK, click Finish to close the Wizard, then restart
your computer.
Installing the CATALYST™ Software
page 19),
on page 13.