Advertisement
16. Position the side brackets on the CD changer and
install the four 4 x 8 mm washer-screws included
in the attachment kit.
CD CHANGER
CD CHANGER
BRACKET A
4 x 8 mm
WASHER-
SCREW
17. Remove the adhesive backings from the CD
changer cushions A and B, and attach them to
both sides of the CD changer.
CD CHANGER
CUSHION B
CD CHANGER
CUSHION A
CUSHION
TAPE
(Cut in
half.)
TAPE ATTACHING FACE
(Align with the lines on
the CD changer.)
18. Using scissors, cut the cushion tape in half.
Attach the two cushion tapes to the CD changer in
the areas shown.
© 2005 American Honda Motor Co., Inc. - All Rights Reserved.
4 x 8 mm
WASHER-
CD CHANGER
SCREW
BRACKET B
2221060K
CD
CHANGER
BRACKET B
CD
CHANGER
CD CHANGER
CUSHION B
CD CHANGER
2221071K
19. Using a tape measure and a felt-tip pen, measure
and mark the center console box inner cover as
shown.
Remove the
marked areas
with a file.
20. While wearing eye protection, drill a 10 mm hole at
the marked location. First drill with a 3 mm drill bit,
and finish with a 10 mm drill bit. After drilling,
remove any burrs, and any material from the hole
using a round file.
21. Locate the four marks on the front and rear of the
center console box. While wearing eye protection,
drill with a 3 mm bit, and finish with a 7 mm bit
through each marked location. After drilling,
remove any burrs from the edges of the holes with
a round file.
CENTER
CONSOLE
BOX
DRILL BIT
(Drill first with
a 3 mm drill
bit, then finish
with a 7 mm
drill bit.)
DRILL
AII 30200 (0508)
CENTER CONSOLE
BOX INNER COVER
5 mm
5 mm
2221050K
DRILL BIT
(Drill first with a 3 mm
drill bit, then finish
with a 7 mm drill bit.)
DRILL
FRONT
CENTER
CONSOLE
BOX
REAR
2221080K
7 of 13
Advertisement
