Dispensing Steam Through The Steam Boiler - Baumatic BAEC2SS.2 User Manual

Noise generated during this operation is perfectly
normal. This is caused by the activation of the high
pressure pump during this operation.
It is also quite normal for a certain amount of water
to drip into the drip tray after water has been
dispensed.

2) Dispensing steam through the steam boiler

o Follow the instructions on filling the water reservoir (pages 12 –
13) as stated previously and proceed as follows:-
o Press the steam boiler activation button (31) to allow the boilers
to heat up. During this process, the steam boiler status indicator
(25) will flash.
o Whilst the steam boiler is heating up, it is normal to get a small
amount of water dripping from the pipe for boiling water and
steam. (17).
o When the boilers have reached their operating temperature, the
steam boiler status indicator (25) will stop flashing and remain
steady.
o To dispense steam, press the steam boiler dispensing button
(32).
NOTE: Steam will dispense from the pipe for boiling water and
steam (17).
o To stop steam from dispensing, press the same button again.
The noise generated during this operation is perfectly
normal. This is caused by the activation of the high
pressure pump during this operation.
It is also quiet normal for a certain amount of water to
drip into the drip tray after water has been dispensed.
o WARNING: During
extreme caution
exercised, as the dispensing pipe wi
get hot.
o When releasing
directing the steam towards your
person. There
scalding.
o Always use a container or a mug
underneath
this operation,
should
steam,
is a danger
the dispen sing
be
ll
avoid
of
pipe
14