Getting Started (Loading The System With Water); Using Your Espresso Maker; Dispensing Hot Water Through The Main Boiler - Baumatic BAEC2SS.2 User Manual

o Restart the machine using the power ON/OFF switch (20).
o You must start the drinks making process right from the
beginning, as stated in the "Using your espresso maker" section
(pages 15 – 17).

3) Getting started (Loading the system with water)

IMPORTANT: YOU MUST FOLLOW THE STEPS BELOW
BEFORE HEATING THE WATER BOILER FOR THE
FIRST TIME.
o Place a jug below the pipe (for boiling water and steam) (17).
o Push the boiling water dispensing button (33).
o Allow the appliance to have a constant flow of water running
through the system for a few seconds.
o Press the boiling water dispensing button (33) again to stop the
flow of water from the pipe.

Using your espresso maker

IMPORTANT: Please note that the main boiler and
the steam boiler CANNOT be operated at the same
time.

1) Dispensing hot water through the main boiler

o Follow the instructions on filling the water reservoir as stated
previously and proceed as follows:-
o Press the main boiler activation button (29) to allow the boiler
to heat up. During this process, the main boiler status indicator
(23) will flash.
o When the boiler has reached its operating temperature, the main
boiler status indicator (23) will stop flashing and remain steady.
o Place a cup underneath the filter holder ring nut (19) and then
press the main boiler dispensing button (30).
o To stop hot water from dispensing, press the same button again.
13