Using Your Espresso Maker; Dispensing Hot Water Through The Main Boiler; Dispensing Steam Through The Steam Boiler - Baumatic PECM1SS Instruction Manual

Using your espresso maker

IMPORTANT: Please note that the main boiler and
the steam boiler CANNOT be operated at the same
time.

1) Dispensing hot water through the main boiler

o Follow the instructions on filling the water reservoir as stated
previously and proceed as follows:-
o Press the main boiler activation button (29) to allow the boiler
to heat up. During this process, the main boiler status indicator
(23) will flash.
o When the boiler has reached its operating temperature, the main
boiler status indicator (23) will stop flashing and remain steady.
o Place a cup underneath the filter holder ring nut (19) and then
press the main boiler dispensing button (30).
o To stop hot water from dispensing, press the same button again.
Noise generated during this operation is perfectly
normal. This is caused by the activation of the high
pressure pump during this operation.
It is also quiet normal for a certain amount of water
to drip into the drip tray after water has been
dispensed.

2) Dispensing steam through the steam boiler

o Follow the instructions on filling the water reservoir (pages 11 –
14) as stated previously and proceed as follows:-
o Press the steam boiler activation button (31) to allow the boilers
to heat up. During this process, the steam boiler status indicator
(25) will flash.
o Whilst the steam boiler is heating up, it is normal to get a small
amount of water dripping from the pipe for boiling water and
steam. (17).
o When the boilers have reached their operating temperature, the
steam boiler status indicator (25) will stop flashing and remain
steady.
15