Additional Things You Should Know - Kenmore 253-35568 Owner's Manual

Hide thumbs

Table Of Contents

Table of Contents

Air Conditioner Features

(continued)

HEATING FEATURE

(on some models):

Temp/Timer

Auto Cool

Med

Cool

Power Saver

Fan Only

Temp/Timer

Mode

T er

Note: This feature can be used with any combination of FAN Speeds , Timer, or Sleep Modes . When in the " Heat " Mode ,

the fan will run continuously while heat is needed. The temperature will automatically be maintained any where between

55¡ãF (13¡ãC) and 80¡ãF (27¡ãC). When the room set temperature is satisfied, the fan will cycle off and on to circulate and sample

the room air.

FAULT CODES:

Auto Cool

Med

Cool

Power Saver

Fan Only

Mode

If the display reads " AS ", a sensor has

failed. Contact your Authorized

KENMORE Service Center

TO TURN UNIT OFF

Temp/Timer

Auto Cool

Med

Cool

Power Saver

Fan Only

Temp/Timer

Mode

T er

Now that you have mastered the operating procedure, here are more features in your control that you should know.

The Remote Control will operate all the control panel features, follow the same instructions.

The "Cool" circuit has an automatic 3 minute time delayed start if the unit is turned off and on

quickly. This prevents overheating of the compressor and possible circuit breaker tripping.

The fan will continue to run during this time.

The Control will maintain any set temperature between 60¡ãF and 90¡ãF degree (cooling), 55¡ãF and 80¡ãF (heating).

The Control is capable of displaying temperature in degrees Fahrenheit or degree Celsius. To convert from one to the other,

press and hold the Up and Down Temperature Selection Pads at the same time for 3 seconds.

Check

Sleep

Filter

MODE BUTTON

Remote

Sensing

Temp/Timer

Check

Sleep

Filter

Temp/Timer

Remote

Sensing

T er

Check

Sleep

Filter

PRESS ON/OFF

Remote

Sensing