Kenmore 253-35568 Owner's Manual page 8

Air Conditioner Features
(continued)
SLEEP FEATURE:
Temp/Timer
Auto Cool
Hi
Med
Lo
Cool
Power Saver
Fan Only
Temp/Timer
Mode
T er
Note: In this "MODE" the selected cooling temperature will increase by 2 degrees F, 30 minutes after the mode is selected. The
temperature will then increase by another 2 degrees F, after an additional 30 minutes. This new temperature will be maintained
for 7 hours before it returns to the originally selected temperature. This ends the "Sleep" MODE and the unit will contunue to
operate as ariginally programmed. The "Sleep" MODE program can be cancelled at any time during operation by pressing
"Sleep" MODE button.
CHECK FILTER FEATURE:
Temp/Timer
Auto Cool
Hi
Med
Lo
Cool
Power Saver
Fan Only
Temp/Timer
Mode
T er
Note: This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation and cooling. The LED
(light) will illuminate after 250 hours of operation. To reset after cleaning the filter, press the "Check Filter" button and light will
go off.
REMOTE SENSING FEATURE
(on some models):
DO THIS:
PRESS SENSING
START BUTTON
Note: This feature can be activated from the remote control ONLY. The unit must be in the cooling mode.
To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing button. Next,
use the or buttons to set desired temperature at the remote. (Note that the set temperature will noly be displayed on the
unit itself.) The LIGHT on the unit control will pulse to indicate it received the signal. The LIGHT on the unit remote control will
pulse each time it sends a signal. It will continue to send this signal until the feature is deactivated by pressing the remote
sensing button. If the unit does receive the remote sensing signal during any 3 minute interval, the unit will beep to indicate
the remote sensing mode has ended. The display on the remote control indicates the temperature at the remote ONLY.
Check
Sleep
Filter
PRESS SLEEP
Remote
Sensing
Check
Sleep
Filter
PRESS TO RESET
Remote
Sensing
Auto Cool
Hi
Med
Lo
Cool
Power Saver
Fan Only
Mode
DO THIS:
PAD
DO THIS:
Temp/Timer
Check
Sleep
Filter
Temp/Timer
Remote
Sensing
T er
8
YOU WILL SEE
Temp/Timer
Auto Cool
Hi
Med
Lo
Cool
Power Saver
Fan Only
Temp/Timer
Mode
Remote
Sensing
T er
Temp/Timer
Auto Cool
Hi
Med
Lo
Cool
Power Saver
Fan Only
Temp/Timer
Mode
Remote
Sensing
T er
YOU WILL SEE
Note: remote display is actual
termperature at remote
control only
LIGHT ON
Check
Sleep
Filter
LIGHT ON
Check
Sleep
Filter