To Operate On Fan Only; Power Saver Feature - Kenmore 253-35568 Owner's Manual

Air Conditioner Features
(continued)

TO OPERATE ON FAN ONLY:

Temp/Timer
Auto Cool
Hi
Med
Lo
Cool
Power Saver
Fan Only
Temp/Timer
Mode
T er
Note: Use this function only when cooling is not desired, such as for room air circulation.
You can choose any fan speed you prefer, EXCEPT AUTO TEMP.
During this function, the display will show the actual current temperature, not the set temperature as in the cooling mode.
TO USE THE

POWER SAVER FEATURE:

Temp/Timer
Auto Cool
Hi
Med
Lo
Cool
Power Saver
Fan Only
Temp/Timer
Mode
T er
Note: In this mode, the fan will continue to fun for 3 minutes after the compressor shuts off. The fan then cycles on for 2
minutes at 10 mintute intervals until the room temperature is abvove the set temperature, at which itme the unit cooling system
starts again.
TIMER-DELAY
START/STOP FEATURE:
Temp/Timer
Auto Cool
Hi
Med
Lo
Cool
Power Saver
Fan Only
Temp/Timer
Mode
T er
Note 1: For Delay Stop, the unit must be in the ON position.
Note 2: For Delay Start, the unit must be in the OFF position.
To adjust timer setting, tap or hold the UP arrow (^) or DOWN arrow (v) to change the delay time by 5 hour increments up to
10 hours, then by 11 hour increments up to 24 hours. The control will count down the timer remaining until start (8,7.5,7,etc).
The Delay Start mode automatically selects cooling with maximum Fan Speed. The temperature maintained will be the same as
previously set. To change the set temperature, press "COOL" then Up or Down arrows until the desired temperature is indicated
on the display. After 5 seconds, the control will automatically change the display back to the hours remaining until the unit will
start/stop. Turning the unit "ON" or "OFF" at any timer will cancel the Delay Start/Stop function. The Delay Start/Stop feature will
work until the unit either starts or stops. Once this has happened then the above steps have to be repeated again.
Check
Sleep
Filter
MODE BUTTON
Remote
Sensing
.
Check
Sleep
Filter
MODE BUTTON
Remote
Sensing
DO THIS:
PRESS TIMER
BUTTOM
Check
Sleep
Filter
Remote PRESS TEMP/TIMER
Sensing
BUTTOM
LIGHT ON
DO THIS:
PRESS
CHOOSE
FAN ONLY
LIGHT ON
DO THIS:
PRESS
CHOOSE
POWER SAVER
FIRST
THEN
DO THIS:
5
YOU WILL SEE
Temp/Timer
Auto Cool
Hi
Med
Lo
Cool
Power Saver
Fan Only
Temp/Timer
Mode
Remote
Sensing
T er
YOU WILL SEE
Temp/Timer
Auto Cool
Hi
Med
Lo
Cool
Power Saver
Fan Only
Temp/Timer
Mode
Remote
Sensing
T er
YOU WILL SEE
Temp/Timer
Auto Cool
Hi
Med
Lo
Cool
Power Saver
Fan Only
Temp/Timer
Mode
Sensing
T er
LIGHT ON
Check
Sleep
Filter
Check
Sleep
Filter
Check
Sleep
Filter
Remote