AT&T 945 User Manual page 16

945 CIB 2ATT 3/14/05
Table/Desk Installation
continued from page 11
2 Connect the handset cord.
Plug one end of the coiled handset cord into the jack on the left
side of the phone. Plug the other end into the handset and hang up.
3 Connect the power adapter to the telephone.
Plug one end of the power adapter into the jack labeled POWER
on the back of the phone. Plug the other end into a standard
electrical outlet not controlled by a wall switch.
4 Initialization.
If no battery is installed when you connect the power cord,
the phone runs a quick self-test and the screen displays
NOTE: The phone will run through this same initialization any time it is
reconnected to AC power if a working battery is not installed (for example,
after a power failure or when the unit has been unplugged).
5 Check for dial tone.
Lift the handset and listen for a dial tone. If you cannot hear a dial
tone, turn to IN CASE OF DIFFICULTY beginning on page 66.
12
9:58 AM Page 12
Use only the power adapter provided with this product.
To obtain a replacement, call
POWER jack
for about seven seconds.
1 800 222–3111
.
Standard
electrical
outlet
Power adapter