Schumacher PID-200-USB Owner's Manual page 9

CONNECTING INVERTER CABLE TO A VEHICLE
(Models PID-200-USB and PID-500-USB) (120 watts
maximum):
1. Remove the cigarette lighter from its outlet.
2. Push the 12-volt power plug firmly into the outlet.
CONNECTING INVERTER CABLES TO 12V BATTERY
OR 12V POWER SOURCE (PID-500-USB and PID-
750):
1. Keep hands, hair, clothing and jewelry clear of bat-
tery terminals.
2. Wear eye protection and clothing protection.
3. Connect the negative (black) inverter terminal cable
to the power source negative (-) or battery terminal.
Make sure the connection is secure.
4. Connect the positive (red) inverter terminal cable
to the power source positive (+) or battery terminal.
Make sure the connection is secure.
5.To disconnect the inverter, reverse the above steps.
NOTE: The internal speaker may make a brief "beep"
when the inverter is being connected to or disconnected
from the 12-volt power source.
ATTENTION: Failure to make the correct connections
will result in blown fuses and permanent damage to the
inverter.
9 •
•