Load The Discs; Unload The Discs; Set Your Printing Preferences - Rimage Producer 8100N User Manual

Rimage Producer™ IIIN+ User Guide

Load the Discs

You can load up to 100 discs in each bin. You can either remove
the carousel to load discs, or use the procedure below to place
discs in a bin.
Open the front door.
1.
Press the operator button to rotate the carousel and place
2.
a bin in position to load discs.
After removing all completed discs from the bin, place up to
3.
100 discs to be recorded in the bin.
-
Important! Place the discs with the recording side
facing down.
Tip: You may designate bins 1 through 4 as input,
output, reject, or a specific media type through your
software.
4. Repeat steps 2 - 3 until the required bins are filled.
5. Close the front door.

Unload the Discs

Open the front door.
1.
Press the operator button to rotate the carousel and place a bin in position to remove discs.
2.
Remove all discs from the bin.
3.
Repeat steps 2 - 3 until the required bins are empty.
4.
Close the front door.
5.

Set Your Printing Preferences

Printing preferences allow you to set up and run your Producer III to produce the best possible label on your discs. Refer to
your printer user guide for specific printing preferences instructions.
14
7100N/8100N/6100N/6100
2001475_A