Stereo Headphone Jack - Akai CDP-280 Operator's Manual

NOTES:
• If the PLAY/PAUSE
is pressed to store a track, the track will not be programmed, and the disc will start
playing from the first selected track.
• Any track can be programmed to play more than once.
• Repeatedly pressing the PROGRAM(Memory)/C-adj button will enable you to check
the program if required.
LISTENING TO PROGRAMMED TRACKS
1. Enter all tracks you want to program into memory following the procedures above.
2. Press the PLAY/PAUSE
programmed track. "PROG" indicator appears on the display display.
TO CLEAR THE PROGRAM MEMORY
• press PROGRAM(Memory)/C-adj button to enter programming mode, then press the
Stop button.
• The program memory will also be cleared if the disc compartment is opened, if the
function is changed, or if the power is turned "OFF".
MUTE
• Press the MUTE button on the remote control to switch off the sound, the MUTE
indicator will appear.
• Press MUTE button again to restore the sound to the previous level.

STEREO HEADPHONE JACK

For private listening without disturbing others connect a set of stereo headphones (not
included) to the PHONES Jack on the front panel. The built-in speakers automatically
shut off when stereo headphones are connected to the headphone jack. When using
stereo headphones always start with the volume control set to a low level and gradually
increase until you find the desired level.
button is pressed before the PROGRAM(Memory)/C-adj button
button. Disc play will start at the beginning of the first
E 14