Disc Play - Akai CDP-280 Operator's Manual

DISC PLAY

1. Insert a CD as described in the previous section and close the disc compartment.
2. The display will then show the total number of tracks and total play time.
3. Press the PLAY/PAUSE
track of the disc.
4. As each track on the CD disc is played, show in the display.
5. A particular track can be selected using either of the CD Skip
this is done before pressing the PLAY/PAUSE
the selected track when the PLAY/PAUSE
6. At the end of the disc, the unit will switch to stop mode.
NOTES:
• If the disc is deeply scratched, or too dirty, disc play may not start.
• If the disc is inserted incorrectly, or the disc is damaged the "no disc" indicator will
appear on display.
DISC ERRORS
• This compact disc player has built-in error compensation circuits to correct for minor
defects in a disc. There are limits, however, to the amount of correction available.
• In some cases, the CD player may skip some tracks, or parts of tracks, on a disc during
disc play. This problem may be caused by defects (such as scratches) in the disc being
played, which are too large for the error compensation circuits to handle. If you encounter
this problem, check the CD player's operation as follows, before having the until serviced:
Play a new disc. If the CD player operates normally, the skipping problem is probably
due to a defective disc.
button. Disc play will begin from the start of the first
E 10
button, disc play will start with
button is pressed.
buttons. If
/