Table of Contents
Advertisement
Ceiling Mount
Notes:
l The included screws and anchors are used to install the
camera to a solid surface. (e.g. concrete) If installing on loose
or thin material surfaces , use the appropriate anchors (not
included) with the screws.
l If possible, point the TOSHIBA logo towards the field of view.
The adjustment range of PAN is indicated on the alignment sticker.
l When installing the camera to the wall, don't turn the lens cover,
and make sure the light sensor location as shown. (Refer to
"Adjusting the Lens" on page 19.)
l Install the camera securely.
l Use Category (Cat) 5 or higher cable.
Mounting the camera to a solid surface
1. Attach the Alignment Sticker to the surface.
2. Drill two pilot holes (Ø0.20inch×0.99inches(D)
(Ø5mm×25mm(D))) through the two circles on the sticker.
3. Hammer the supplied plastic anchors into the holes.
4. Drill a cable hole A(Ø1.1inch (Ø28mm)) as shown in the above picture, and lead the
cables through this hole.
5. Align the two mounting holes of the Camera with the two plastic anchors; insert the
included two screws to the corresponding holes and tighten them with a driver.
Cable installation
If possible, lead all cables behind the camera body through a wall or ceiling.
If this is not possible, use the knock out on the camera cover to route the cables through the
side. (Refer to "Completion" on page 20.)
CAUTION
l Installation should be done only by qualified personnel and conform to all local codes.
l Install this camera on a firm and solid part of the ceiling or wall.
If installed improperly or on a weak surface, the camera could fall causing injury and
damage.
14
14
14
Wall Mount
Advertisement
Table of Contents
