Hardware Installation - Toshiba IK-WD05A Quick Start Manual And Important Safeguards

Hardware Installation

First, follow the instructions below to remove the dome cover. Flip the black
retention tabs in the counter-clockwise direction to release the dome cover
(clockwise if you look from the bottom up.)
Then remove the black cover as shown below.
NOTE
Protection film is placed on the lens at the factory. In order to protect the lens,
do not remove until lens adjustment is completed.
(Refer to "completion" on page 20.)
12
Record the MAC address before
installing the camera.
Tilt Adjustment Screws
Lens Cover
Mounting hole
Clear cover
Dome cover