•
Check horizontal alignment of the doors and, if
necessary, correct their position by moving them
along the slots.
•
Open the door.
Adjust the planarity of the doors by means of the
adjustment bushings and the lower square.
•
Once the doors are perfectly and completely
aligned, fix a clamp screw inside the bushings
(upper and lower hinge) on the lower bracket.
The screws must be tighten completely inside the
slots.
Building the appliance in
•
Fit the appliance into the recess.
•
Rotate the bracket of 180° in order to obtain the
right position (2).
The position (1) is on the delivery.
•
Fix it to the wali with the appropriate bracket.
•
The top of the appliance must be kept ciear to
allow better air circulation. If a wall unit is fitted
above the appliance, there must be a gap of 50
mm between this unit and the wall and it must be
at least 50 mm below the ceiling.
30
1
2
50
50
25