Programming The Demomessage; Resetting The Cpu - Yaesu FT-90R Operating Manual

Miscellaneous Settings
Programming the Demo Message
You also can change the Demonstration mode message, if desired, using the
following procedure:
1. Press and hold in the
notice the first character of the upper message area blinking.
2. While this character is blinking, rotate the M
character of the top message, then press the
character to the right.
3. Rotate the M
key to move on to the next character's entry location.
4. Repeat steps 2 and 3, as necessary, to complete the upper message (up to 50
characters).
5. Now press the
ter of the lower message area blinking.
6. Repeat steps 2 and 3 again to set the lower message (up to 50 characters).
7. Press the

Resetting the CPU

If you encounter erratic operating results, or wish to clear all transceiver settings
so as to start with the factory defaults, resetting the microprocessor provides a
quick method of "starting over" with original factory settings.
m To reset all M
procedure does not alter or erase any channel memories you may have stored.
m To perform a CPU master reset for all memories and M
and hold in the
turning the transceiver on.
50
D
knob to select the next character, then press the
AIN IAL
key momentarily; you will now observe the first charac-
key to save the new messages and exit.
settings to their factory defaults, press and hold in the
ENU
key and the
key, the
key while turning the transceiver on; you will
AIN
button while turning the transceiver on. This
key, and the
FT-90R O
D
knob to select the first
IAL
key to move on to the next
settings, press
ENU
button while
PERATING
M
ANUAL