Yaesu FT-90R Operating Manual page 59

Menu System
26Pg:AC
Function: Programming the [ ACC ] button assignment.
Available Values: TONE, PRI, SCAN UP, SCAN DWN, RPTR, REVERSE,
TX PWR, HOME CH, VFO/MR, T.BURST
Default Setting: PRI
27RfSql
Function: Adjust the RF SQL threshold level.
Available Values: S-3/S-5/S-FULL/OFF
Default Setting: OFF
28RPTR
Function: Setting the Repeater Shift Direction.
Available Values: ARS/Shift -/Shift +/OFF (Simplex)
Default Setting: ARS (Automatic Repeater Shift)
29SCAN
Function: Select the Scan-Resume mode.
Available Values: BUSY/TIME
Default Setting: BUSY
Note:
"TIME" is a five-second delay, after which scanning will resume.
30Shift
Function: Set the magnitude of the Repeater Shift.
Available Values: 0.00MHz ~ 99.95 MHz (50 kHz steps)
Default Setting: Depends on transceiver version (U.S.A., European, etc.).
Note:
Different shifts will appear, depending on the band you currently are on.
31SKIP
Function: Enable/disable skipping of a memory during scanning.
Available Values: SKIP/STOP
Default Setting: STOP (Scanner stops when the channel is busy)
32STEP
Function: Setting the synthesizer steps.
Available Values: 5.0/10.0/12.5/15.0/20.0/25.0/50.0 kHz
Default Setting: Depends on the transceiver version (U.S.A., European, etc.).
57
FT-90R O M
PERATING ANUAL