Packet Operation - Yaesu FT-90R Operating Manual

Packet operation generally requires only that you connect your TNC per the illus-
tration on page 16, then configure the channel for 1200 bps or 9600 bps using the
M .
ENU
To select the Packet baud rate, use the following procedure:
1. Press and hold in the
knob to select "2 1 P C K T ."
2. Press the
3. Press and hold in the
exit to normal operation.
The packet baud rate selection can be set independently for each band (VHF and
UHF) during VFO operation. Note also that the packet baud rate may be stored
into memory channels, so you won't need to enter the M
operate in the Packet mode.
FT-90R O
PERATING
key for one second, then rotate the M
key to select the desired baud rate (1 2 0 0 b p s or 9 6 0 0 b p s ).
key for 1.5 second to save the new setting and
M
ANUAL

Packet Operation

each time you wish to
ENU
D
AIN IAL
45