WingScapes BirdCam User Manual page 30

SETUP Menu
LOW – This value should be used when you are getting too
many images using the MEDIUM value. This may happen when
the BirdCam is mounted very close to its target or if many birds
are flying behind the feeder without landing.
MEDIUM – This option is the default factory value and should
be used in most cases. When you are trying a new mounting
location, test results using this MEDIUM value and then adjust to
HIGH or LOW accordingly.
HIGH – Use this setting if you think the BirdCam is not
triggering often enough with the MEDIUM value selected. This
value can be useful when the distance between BirdCam and
target is farther than 5 feet or when you are trying to capture
smaller birds.
IMPRINT INFO?
This setting allows you to imprint the time and date that a photo
was taken, along with a camera name in a databar at the bottom
of your photos. The databar does reduce the vertical dimensions
of your photo image area slightly. There are three options for this
setting.
30