Table of Contents
Advertisement
4. Specify the desired command with the directional
arrows (for example, «Load Single Song»).
Use the
button to move into the quantity
column and select the file quantity (Single,
Group, All) with the / buttons.
Pass over to the other column with the but-
ton and select the file type (Sound, Perform-
ance, Song, etc.) with the / buttons.
5. Press ENTER to confirm the command and open
the File Selector.
The "Wait Please" message appears for an
instant before opening the File Selector.
The file selector now shows the source di-
rectory consisting of one or more Blocks to
choose from, and the destination directory
representing the sector of RAM correspond-
ing to the file type being handled (in this case
the Song memory).
This display example shows the floppy disk
directory (a) with a single Block file, and the
instrument's RAM directory (b) showing the
empty Song memory. The disk name is
shown at the top of the left column (c). If the
disk has no name, either "NO NAME" or
"UNTITLED" or other will be shown.
Note: At this point, to exit from «Edit Disk»,
press DISK . Escape exits the File selector.
6. Select a Block and press ENTER to gain access.
The contents of the opened Block reveals the
file type selected in step 4 (in this case, sev-
eral Songs in numerical order).
At the bottom of both columns, information
regarding the selected file will appear. In this
case, the left column shows the date that the
file was created and its dimensions expressed
in Kb (d). The right column is blank and rep-
resents the empty destination.
4
5
(c)
(a)
6
(d)
Disk & Hard Disk 3•5
(b)
Advertisement
Table of Contents
