Table of Contents
Advertisement
3. Specify the Save operation required (example,
Save All Song) then press ENTER to open the File
Selector.
4. Select an existing Block to save to or empty des-
tination to create a new Block.
Save to an existing Block to backup your data
after a work session when the destination
Block and RAM block are of the same origin.
Select an empty destination (shown as a bro-
ken line with .BLK extension) to create new
block.
5. Press ENTER.
If you selected an existing Block, the opera-
tion will proceed depending on specified com-
mand.
If you save to an empty location, you'll be
prompted to create a new Block. Use the
keyboard and the numeric keypad as the
sources of alphanumeric data to give the
block a name (see Data Entry procedures in
chapter 1). The extension ".BLK" is created
automatically. Confirm the new name with
ENTER.
6. Press ENTER to confirm the Save operation.
The existing Block will be updated or the new
Block will be created and the file(s) will be
saved to the Block.
Remember that if you save to an existing file,
it will be overwritten by the incoming one.
Whenever possible, try to save to an empty
location (shown as a broken line) to safeguard
existing data on the storage device.
7. When you have finished, press DISK (or ESCAPE
three times) to exit «Disk».
3•16 Reference Guide
3
4
5/6/7
or
Advertisement
Table of Contents
