Westinghouse WH4500 Owner's Manual page 15

4. Install the mounting feet to the frame using four
M6 x 18 mm bolts and M6 locking fl ange nuts (see
Figure 7).
Figure 7 – Assemble Mounting Feet to Frame
1 - Mounting Feet
2 - M6 x 18 mm
Bolts
5. Install the M12 x 105 mm wheel axle fl ange bolt
through the wheel (see Figure 8).
6. Thread the M12 serrated fl ange nut onto the bolt
with serrated edges facing away from the wheel.
Tighten the nut (see Figure 8).
Figure 8 – Installing Outside Serrated Flange Nut
1 - Wheel Axle
Flange Bolt
7. Install the wheel with bolt through the axle bracket
on the frame (see Figure 9).
8. Install the serrated fl ange nut and tighten (see
Figure 9).
3 - M6 Locking
Flange Nuts
2 - Serrated Flange
Nut
ASSEMBLY
Figure 9 – Assemble Wheels to Frame
1 - Axle Bracket
9. Install the handles using the clevis pin and hairpin
cotter. Install the nylon washers on the outside and
inside of the handle as shown in Figure 10.
Figure 10 – Attaching the Handles
1 - Clevis Pin
2 - Handle
2 - Serrated Flange
Nut
3 - Nylon Washers
4 - Hairpin Cotter
15