Dmx Operation; Master/Slave Mode; Standalone; Automatic - Chauvet SlimPAR Pro VW User Manual

DMX Operation

This is the operating mode which will allow for control with an external DMX controller. You must set
the starting address for this mode.
Only connect 32 fixtures to a single DMX daisy chain!

Master/Slave Mode

This mode allows a single unit, the master, to operate in one of the standalone modes, while one or
more fixtures, slaves, synchronize their responses to the master. Master: The master fixture may be
set in any of the STANDALONE modes listed in this user manual. Slave: Set the slave fixture(s) to
DMX mode at starting address 001.
Only connect 31 slave fixtures when operating in this mode!

Standalone

This fixture has several options for operating without a DMX controller. Access these options via the
control panel on the back of the fixture.

Automatic

This fixture has preprogrammed chases that may be triggered without a controller. Access these
chases via the control panel on the back of the fixture.

Color Temperature Preset

This fixture has preprogrammed, static color temperature presets that may be triggered without a
controller. Access these chases via the control panel on the back of the fixture.

Custom Color Temperature

This fixture has the ability to accept a custom static color temperature setting. Access this via the
control panel.
SlimPAR Pro VW User Manual
1. Plug a DMX controller into the fixture in a daisy chain configuration.
Press <MENU> until the following appears on the LED screen: PeRS.
2.
3. Press <ENTER>.
4. Using <UP> & <DOWN>, select the desired personality (7-CH, 3-CH, 2-CH).
5. Press <ENTER>.
6. Press <MENU> until AddR appears on the LED screen.
7. Press <ENTER>.
8. Using <UP> & <DOWN>, select the desired DMX starting address (d001~d512).
9. Press <ENTER>.
1. Remove any DMX controller from the fixture.
2. Press <MENU> to select Auto Program (
3. Press <ENTER>.
4. Using <UP> & <DOWN>, select one of the 5 programs.
5. Press <ENTER>.
S000~S100
6. Press <MENU> until
7. Press <ENTER>.
8. Using <UP> & <DOWN>, select the desired run speed (slow~fast)
9. Press <ENTER>.
1. Remove any DMX controller from the fixture.
2. Press <MENU> to select Color Temperature Preset mode (
3. Press <ENTER>.
4. Using <UP> & <DOWN>, select one of the nine presets.
5. Press <ENTER>.
U--
1. Press <MENU> until
2. Press <ENTER>.
3. Using <UP> and <DOWN>, select the desired color.
4. Press <ENTER>.
5. Using <UP> and <DOWN>, select the desired color value (
the color will remain off.
Press <ENTER> to continue to the next color (
6.
7. Using <UP> and <DOWN>, select the desired color value (
8. Continue until the desired mix is obtained. The order of colors is warm white and cool white.
9. Press <ENTER> to continue to the strobe setting.
10. Using <UP> and <DOWN>, select the desired strobe value (
the strobe function will remain off.
11. Press <ENTER> to save the final color setting. This will move the selection to the following
color. However, this is necessary to save the modification.
P--
).
appears on the LED screen.
appears on the LED screen.
A, W
).
11
C--
).
000 100 000
~ ). By selecting
000 100
~ ).
000 100 000
~ ). By selecting
,
,
Rev. 3