Table of Contents
Advertisement
Operation
DMX Operation
DMX Channel Values
4. Operating Instructions
This operating mode will allow for control with an external DMX controller. You must set the
starting address for this mode.
If this is your first time using DMX, then it is recommended that you refer to the "DMX Primer"
section in the "Appendix" of this manual.
Please see the instructions below for details on this mode.
1.
Plug the fixture into power.
2.
Plug a DMX controller into the fixture in a daisy chain configuration.
3.
Press <MODE> until 512 appears on the LED screen.
4.
Press <ENTER>.
5.
Using <UP> & <DOWN>, select the DMX starting address.
6.
Press <ENTER>.
When the fixture is in DMX mode, the red DMX LED will illuminate.
When the fixture is in DMX mode and addressed to A001, the yellow SLAVE LED will
illuminate. This is normal.
C
V
F
HANNEL
ALUE
UNCTION
Color/Mode
000 ó 009
Blackout
010 ó 014
Red
015 ó 019
Green
020 ó 024
Blue
025 ó 029
Amber
030 ó 034
Green + blue
035 ó 039
Red + blue
040 ó 044
Red + green
045 ó 049
Red + amber
1
050 ó 054
Green + amber
055 ó 059
Blue + amber
060 ó 064
Red + green + blue
065 ó 069
Green + blue + amber
070 ó 074
Red + blue + amber
075 ó 079
Red + green + blue + amber
080 ó 139
Automatic (single colors only)
140 ó 199
Automatic (two colors at a time)
200 ó 249
Automatic
250 ó 255
Sound-active
Automatic Speed (when CH1 is between 094~255)
2
160 ó 255
Slow ó fast
Strobe
000 ó 004
3
No Function
005 ó 255
Strobe (slow ó fast) (max 30 Hz)
Motor Rotation
000 ó 004
Stop
005 ó 127
4
Rotate clockwise
128 ó 133
Stop
134 ó 255
Rotate counter-clockwise
9
1/7/2011 4:34 PM
Advertisement
Table of Contents
