Technical Information; General Maintenance - Chauvet SCAN LED 200 User Manual

5. T
ECHNICAL

General Maintenance

Intimidator™ Scan LED 200 User Manual (Rev. 4)
I
NFORMATION
Dust build up reduces light output performance and can cause overheating. This can
lead to reduction of the light source's life or mechanical wear. To maintain optimum
performance and minimize wear, you should clean your lighting fixtures at least twice
a month. However, be aware that usage and environmental conditions could be
contributing factors to increase the cleaning frequency.
To clean this fixture, follow the instructions below:
• Unplug the fixture from power.
• Wait until the fixture is cold.
• Use a vacuum (or dry compressed air) and a soft brush to remove dust collected
on the external surface/vents and reachable internal components.
• Clean the mirror and lens with a mild soap solution, ammonia-free glass cleaner,
or isopropyl alcohol.
• Apply the solution directly to a soft, lint free cotton cloth or a lens cleaning tissue.
• Softly drag any dirt or grime to the outside of the mirror and lens.
• Gently polish the mirror and lens until they are free of haze and lint.
• When cleaning the movable mirror, you should keep the contact with the mirror's
surface to a minimum to avoid scratching or damaging it.
Always dry the mirror and lens carefully after cleaning them.
Do not spin the cooling fan/fans using compressed air because you could
damage it/them.
Page 17 of 20