Standalone Operation
Master/Slave Mode (Sound-Active, Auto Mode)
Automatic-Slow
Automatic-Fast
Sound-Active
Page 12 of 20
This mode allows a single unit, the master, to operate in one of the standalone
modes, while one or more fixtures, slaves, synchronize their responses to the master.
Master:
The master fixture may be set in any of the STANDALONE modes: sound-active,
fast, or slow.
Slave:
1) Press <MODE/ESC> until one of the standalone modes appears on the LED
screen (SLAu, nStS, nAFA, nASL).
2) Using <UP> and <DOWN>, select SLAu.
3) Press <ENTER>.
Only connect 32 fixtures to a single DMX daisy chain!
This fixture has a preprogrammed chase that will operate in a preprogrammed, slow
playback speed.
Access this mode via the control panel on the front of the fixture. Please see the
instructions below for further explanation.
1) Press <MODE/ESC> until one of the standalone modes appears on the LED
screen (SLAu, nStS, nAFA, nASL).
2) Using <UP> and <DOWN>, select nASL.
3) Press <ENTER>.
This fixture has a preprogrammed chase that will operate in a preprogrammed, fast
playback speed.
Access this mode via the control panel on the front of the fixture. Please see the
instructions below for further explanation.
1) Press <MODE/ESC> until one of the standalone modes appears on the LED
screen (SLAu, nStS, nAFA, nASL).
2) Using <UP> and <DOWN>, select nAFA.
3) Press <ENTER>.
This fixture has a preprogrammed, sound triggered chase.
Access this via the control panel on the front of the fixture. Please see the chart
below for further explanation.
1) Press <MODE/ESC> until one of the standalone modes appears on the LED
screen (SLAu, nStS, nAFA, nASL).
2) Using <UP> and <DOWN>, select nStS.
3) Press <ENTER>.
The fixture will only respond to the low frequencies of the music (bass and
drums).
Intimidator™ Scan LED 200 User Manual (Rev. 4)