Basic Operations; Understanding Ht502 Voice Prompt; Table 5: Ht502 Ivr Menud; Efinitions - Grandstream Networks HT502 User Manual

B O
ASIC PERATIONS

Understanding HT502 Voice Prompt

HT502 has a built-in voice prompt menu for simple device configuration. The IVR menu and the LED
button work with any of the FXS port. Pick up the handset and dial "***" to use the IVR menu.
T 5: HT502 IVR M
ABLE ENU
Menu Voice Prompt
Main Menu
"Enter a Menu Option"
01 "DHCP Mode",
"Static IP Mode"
02 "IP Address " + IP address
03 "Subnet " + IP address
04
"Gateway " + IP address
05 "DNS Server " + IP address
07 Preferred Vocoder
10 "MAC Address"
12 WAN Port Web Access
13 Firmware Server IP
Address
14 Configuration Server IP
Address
15 Upgrade Protocol
16 Firmware Version
17 Firmware Upgrade
47 "Direct IP Calling"
70 Phone calls between FXS 1
and FXS 2 port
86 Voice Mail
Grandstream Networks, Inc.
D

EFINITIONS

Options
Press "*" for the next menu option
Press "#" to return to the main menu
Enter 01-05, 07,10, 12-17,47 or 99 menu options
Press "9" to toggle the selection
If using "Static IP Mode", configure the IP address information using
menus 02 to 05.
If using "Dynamic IP Mode", all IP address information comes from
the DHCP server automatically after reboot.
The current WAN IP address is announced
If using "Static IP Mode", enter 12 digit new IP address. You need to
reset the HT to take affect the new IP address.
Same as menu 02
Same as menu 02
Same as menu 02
Press "9" to move to the next selection in the list:
•
PCM U / PCM A
•
iLBC
•
G-726
•
G-723
•
G-729
Announces the Mac address of the unit.
Press "9" to toggle between enable / disable
Announces current Firmware Server IP address. Enter 12 digit new
IP address.
Announces current Config Server Path IP address. Enter 12 digit
new IP address.
Upgrade protocol for firmware and configuration update. Press "9" to
toggle between TFTP / HTTP / HTTPS
Firmware version information.
Firmware upgrade mode. Press "9" to toggle among the following
three options:
- always check
- check when pre/suffix changes
- never upgrade
Enter the target IP address to make a direct IP call, after dial tone.
(See "Make a Direct IP Call".)
User can make internal calls between two FXS ports on the same
HT502 even without being registered to SIP server. By dialing *** and
70 user can reach the other FXS port
Number of Voice Mails
HT-502 User Manual
Firmware Version 1.0.4.2
Page 9 of 32
Last Updated: 06/2011